Residential Reverse Osmosis System
and Commercial Systems (Seawater)


Commercial Systems, plus Seawater Systems
other Treatment Systems

TRICHLOROETHANE In Drinking Water

This is a factsheet about a chemical that may be found in some public or private drinking water supplies. It may cause health problems if found in amounts greater than the health standard set by the United States Environmental Protection Agency (EPA).

Trichloroethane is an organic liquid with a chloroform-like odor. It is only used to make vinylidene chloride or 1,1-Dichloroethene which is in turn used to make synthetic fibers and plastic wraps such as the saran wrap.  In 1974, Congress passed the Safe Drinking Water Act. This law requires EPA to determine safe levels of chemicals in drinking water which do or may cause health problems. These non-enforceable levels, based solely on possible health risks and exposure, are called Maximum Contaminant Level Goals.

The MCLG for 1,1,2-TCE has been set at 3 parts per billion (ppb) because EPA believes this level of protection would not cause any of the potential health problems described below.  The MCL has been set at 5 ppb because EPA believes, given present technology and resources, this is the lowest level to which water systems can reasonably be required to remove this contaminant should it occur in drinking water.These drinking water standards and the regulations for ensuring these standards are met, are called National Primary Drinking Water Regulations. All public water supplies must abide by these regulations.

What are the Health Effects?

Short-term: EPA has found 1,1,2-TCE to potentially cause the following health effects when people are exposed to it at levels above the MCL for relatively short periods of time: irritation of gastrointestinal tract; red or hemorrhaged lungs; pale liver  Long-term: 1,1,2-TCE has the potential to cause the following effects from a lifetime exposure at levels above the MCL: damage to liver and kidneys; cancer.

How much 1,1,2-TCE is produced and released to the environment?

An estimated 124 million lbs. of 1,1,2-TCE was produced in the US during 1974, based on the manufacture of vinylidene chloride. It evaporates during its use in the manufacture of vinylidene chloride and as a solvent. It is also released in wastewater from these uses, and in leachates and volatile emissions from landfills. The EPA estimates the gross annual discharge of 1,1,2-TCE waste in the US to be 4 million lbs. From 1987 to 1993, according to EPA's Toxic Chemical Release Inventory, 1,1,2-TCE releases to land and water totaled over 30,000 lbs., of which about 98 percent was to water. These releases were primarily from alkali and chlorine industries. The largest releases occurred in Louisiana and Texas.

What happens to 1,1,2-TCE when it is released to the environment?

When released into water, 1,1,2-TCE should primarily evaporate. In soils, it should partially evaporate and partially leach into the groundwater. Its break down by microbes, if it occurs, is very slow. 1,1,2-TCE shows little tendency to accumulate in aquatic life.

How will 1,1,2-TCE be Detected in and Removed from My Drinking Water?

The regulation for 1,1,2-TCE became effective in 1994. Between 1993 and 1995, EPA required your water supplier to collect water samples every 3 months for one year and analyze them to find out if 1,1,2-TCE is present above 0.5 ppb. If it is present above this level, the system must continue to monitor this contaminant

If contaminant levels are found to be consistently above the MCL, your water supplier must take steps to reduce the amount of 1,1,2-TCE so that it is consistently below that level. The following treatment methods have been approved by EPA for removing 1,1,2-TCE: Granular activated charcoal in combination with Packed Tower Aeration.  

How will I know if 1,1,2-TCE is in my drinking water?

If the levels of 1,1,2-TCE exceed the MCL, 5 ppb, the system must notify the public via newspapers, radio, TV and other means. Additional actions, such as providing alternative drinking water supplies, may be required to prevent serious risks to public health.

Drinking Water Standards:  Get Your Water Tested ! (NTL Partner Site)

Mclg: 3 ppb
Mcl: 5 ppb

Whole House Treatment System

They will be posted here at our New Training Portal
Training Professionals Online Training Courses.